Changing The Abrasive Belt/Disc - Axminster WORKSHOP AW150BDS Original Instructions Manual

CHANGING THE ABRASIVE BELT/DISC

4
The abrasive disc is attached to the sander's face by Velcro,
a strip of fabric that clings when pressed together. Simply
peel off the old abrasive disc. Clean the surface of the disc.
5
6
Line up the new abrasive disc with the face of sanding disc
and using a piece of cloth in your hand or wear a glove, to
firmly press the abrasive to the disc plate, the application
will be reinforced by a gentle sanding action across the
face when you first use the new sanding disc. Re-assemble
the sander.
CONNECT THE SANDER TO THE
MAINS SUPPLY AND CONTINUE
WITH OPERATION.
Linisher Belt
DISCONNECT THE SANDER FROM
THE MAINS SUPPLY BEFORE
CONTINUING!
1
Loosen the two clamping Hex screws holding the linisher
and raise to the vertical position. Tighten the Hex screws.
2
3
Remove the worktable (B) if installed for easy access and
place to one side.
14