Table of Contents
Advertisement
CHANGING THE ABRASIVE BELT/DISC
Sanding Disc
DISCONNECT THE SANDER FROM
THE MAINS SUPPLY BEFORE
CONTINUING!
1
2
3
4
5
Lift the edge of the disc and, gripping firmly, peel the
disc away from the plate; turning the plate as required to
free the entire disc. Clean the surface of the disc, allow to
dry off and wipe over with a clean dry cloth.
Locate the sanding disc, peel the cover from the adhesive
surface and apply CAREFULLY to the disc plate. Use a piece
of cloth in your hand or wear a glove, to firmly press the
abrasive to the disc plate, the application will be reinforced
by a gentle sanding action across the face when you first
use the new sanding disc. Re-assemble the sander.
CONNECT THE SANDER TO THE
MAINS SUPPLY AND CONTINUE
WITH OPERATION.
Linisher Belt
DISCONNECT THE SANDER FROM
THE MAINS SUPPLY BEFORE
CONTINUING!
Raise the linisher to the vertical position.
1
Linisher tilt
clamping bolt
14
Advertisement
Table of Contents
