Setup And Adjustment - Axminster WORKSHOP AW150BDS Original Instructions Manual

SETUP & ADJUSTMENT
2
3
4
Remove the linisher guard (E) clamping Hex screws and
place the guard safely to one side. Replace the two Hex
screws/washers to the side of the linisher.
5
Tighten the two Hex
screws to secure the
linisher in position,
see step 3.
6
7
Transfer the work table (B) from the disc function mount-
ing to the linisher's mounting hole and secure in position.
Setup the table as described earlier, see the following
steps.
8
9
1.6mm clearance required
10
8