Changing The Sanding Disc - Axminster Professional AP305DS Original Instructions Manual

CHANGING THE SANDING DISC

DISCONNECT THE SANDER FROM
THE MAINS SUPPLY BEFORE
CONTINUING!
Fig 10
Step 1 Remove the two table clamping handles (see fig 10).
Fig 11
Step 2 Remove both screws on either side of the table and
place safely aside (see fig 11).
Fig 12
Step 3 Lift the table assembly away and place to one side
(see fig 12).
Step 4 Locate the supplied spanner (C) and using the 10mm
end remove the two nuts on either side of the extraction
housing (see fig 13)
Step 5 Lower the extraction housing (see fig 14).
Step 6 Grip the edge of the adhesive disc and peel away
from the plate; turning the plate as required to free the
entire disc (see fig 15). Clean the surface of the disc with a
de-greasing cleaner. Allow to dry off and wipe over with a
10
Fig 13
Fig 14
Fig 15