Table of Contents
Advertisement
6.5 Adjusting
6.5.1 Angle Adjust
The handle of the belt grinder is in loose condition in a certain angle range, then turn the
handle firm to avoid unexpected accident.
6.5.2 Belt slant Adjust
If the belt is deviated, adjust the belt deviation by rotating the hand wheel after loosening
the screw. When finishing the belt slant adjust, fasten the screw again.
6.5.3 Changing the belt
A satisfied grinding would only be obtained when using a completely clean grinding belt.
Otherwise it must be renewed.
It can be fulfilled by moving eccentric wheel handle to compress the belt machine. After
the sand-band is dismantled and replaced, the eccentric wheel handle should restore to
its original position. Please refer to the detailed step as following:
Switch off the machine.
Ensure the belt is at a complete standstill.
Open the side guard with tools.
Loosen the belt by moving the belt tension release lever from A to B position.
Replace the belt.
Tighten the belt by moving the belt tension release lever from B to A.
Close side guard with tools.
15 / 16
Advertisement
Table of Contents
