Table of Contents
Advertisement
PROBLEM
Motor will not run
Machine slows down
while sanding
Wood burns
while sanding
POSSIBLE CAUSE
1. Defective or broken
"ON -OFF" switch
2. Defective or damaged
switch cord
3. Defective or damaged
switch relay
4. Burned out motor
5. Blown fuse
1. Applying too much pressure
to workpiece
1. Sanding disc/belt is worn
2. Excessive pressure being
applied to workpiece
1-3. Replace all broken or defective parts
before using the sander. Contact us on 03332 406406
4. Contact us on 03332 406406
Customer service enquires cs@axminstertools.com
Servicing, parts & technical support
technicalsupport@axminstertools.com
1. Apply less pressure to sanding surface
1. Replace the disc/belt
2. Reduce pressure being
applied to workpiece
19
TROUBLE SHOOTING
REMEDY
Advertisement
Table of Contents
