Table of Contents
Advertisement
INTRODUCTION
A neatly designed belt and disc sander.
The worktable on the belt and disc sander is a decent size
and used on both functions. The table is easy to transfer
from one function to the other. The table pivots from 0°
to 45° and incorporates a mitre fence running in a slot for
bevel and compound angle sanding. The sanding linisher
also moves from vertical to horizontal with just two
PACKAGING
HAVING UNPACKED YOUR
SANDER, PLEASE DISPOSE OF
THE PACKAGING PROPERLY. THE
PACKAGING IS BIODEGRADABLE.
GENERAL INSTRUCTIONS FOR 230V MACHINES
The following will enable you to observe good working
practices, keep yourself and fellow workers safe and
maintain your tools and equipment in good working order.
WARNING!! KEEP TOOLS AND
EQUIPMENT OUT OF REACH OF
YOUNG CHILDREN
KEEP WORK AREA AS
UNCLUTTERED AS IS PRACTICAL.
UNDER NO CIRCUMSTANCES
SHOULD CHILDREN BE ALLOWED
IN WORK AREAS.
Mains Powered Tools
• T ools are supplied with an attached 13 Amp 3 pin plug,
fitted with 10 amp fuse.
• Inspect the cable and plug to ensure that neither are
damaged. Repair if necessary by a suitably qualified
person.
• Do not use when or where it is liable to get wet.
Workplace
• Do not use 230V a.c. powered tools anywhere
within a site area that is flooded.
• Keep machine clean.
hexagon socket bolts to loosen with a key, suiting the task
in hand. The belt has close fitting guarding which helps this
machine achieve a high level of efficient dust extraction.
When connected to a simple vacuum extractor almost
total dust extraction is achievable. The chassis is heavily
constructed in a single iron casting to support the tables
and belt arm, and has locating holes for securing this
sander to a workbench if you so wish.
Having opened the box, remove the top packaging and lift
the machine out and place upon a clear flat surface, taking
care not to trap or pinch the power cable under the chassis.
Remove the remaining items from the box and place safely
aside.
• Leave machine unplugged until work is about to
commence.
• Always disconnect by pulling on the plug body
and not the cable.
•
Carry out a final check e.g. check the cutting tool
is securely tightened in the machine and the
correct speed and function set.
•
Ensure you are comfortable before you start work,
balanced, not reaching etc.
• Wear appropriate safety clothing, goggles, gloves,
masks etc. Wear ear defenders at all times.
• If you have long hair wear a hair net or helmet to prevent
it being caught up in the rotating parts of the machine.
• Consideration should be given to the removal of rings
and wristwatches.
• Consideration should also be given to non-slip
footwear etc.
• If another person is to use the machine, ensure they are
suitably qualified to use it.
• Do not use the machine if you are tired or distracted.
• Do not use this machine within the designated safety
areas of flammable liquid stores or in areas where there
may be volatile gases.
• Check cutters are correct type and size, are
undamaged and are kept clean and sharp, this will
maintain their operating performance and lessen the
loading on the machine.
• OBSERVE.... make sure you know what is
happening around you and USE YOUR COMMON SENSE.
4
Advertisement
Table of Contents
