GeoVision GV-EBX1100 Series Firmware Manual page 88

Sensitivity: Set the sensitivity for low light detection. The higher
the value, the easier the white illumination LED is to be triggered.
The default value is 5.
The Interval between triggering: Select the duration for the white
illumination LED to light up at full intensity. If a motion persists
over the specified period, the white illumination LED will light up
with less intensity. This option is designed to keep the camera
temperature within its precautious range. The default value is 60
seconds.
Off: Select to disable the white illumination LED.
[Special View Setting] Note this function is not available for GV-BX2600.
D/N: Sets the sensitivity of day-night mode switch. The higher the
sensitivity value, the more sensitive the switch is from day mode to
night mode. The default value is 5.
Auto: Select Auto for the camera to detect the amount of light
present and automatically switch to monochrome in a poorly-lit
scene. Move the slider to adjust the sensitivity level from 0 to 10.
Black and White: Select this option for the live view to be in
monochrome.
Color: Select this option for the live view to be in color.
Triggered by Input: For GV-BX12201 firmware V1.02 or later,
select this option to switch between day mode and night mode
once the input device (e.g. sensor or button) is triggered.
Schedule: For GV-BX12201 firmware V1.02 or later, select this
option to determine specific period(s) of time when day mode is
activated. See 4.6.1 Recording Schedule Settings for the details
on the setting of the schedule.
4 4
Administrator Mode
67