I/O Settings - GeoVision GV-EBX1100 Series Firmware Manual

4.3 I/O Settings

Note the I/O settings are only available for Box Camera, Bullet Camera,
Ultra Bullet Camera, PTZ Camera, PT Camera, Vandal Proof IP Dome,
and Fixed IP Dome.
After installing the I/O device, you need to enable the I/O settings on the
camera. For how to install the I/O device on the camera, see the following
reference sections in the corresponding Hardware Manual:
GV-IPCAM
Box Camera
Bullet Camera
PTZ Camera
PT Camera
Vandal Proof IP Dome
Fixed IP Dome
Reference section
I/O Terminal Block
Connecting the Camera
Connecting the Camera
I/O Terminal Block
I/O Terminal Block
Connecting the Camera
I/O Terminal Block
4 4
Administrator Mode
103