Chapter 5 Recording And Playback; Recording - GeoVision GV-EBX1100 Series Firmware Manual

Chapter 5 Recording and Playback

Note that Recording and Playback function is not available for Target
Series.
The camera can record video and audio directly to the memory card. You
can play back the recorded files on the GV-DVR / NVR / VMS over the
TCP/IP network.
Note: See Note for Recording at the beginning of the manual.

5.1 Recording

To enable the recording function:
1. Insert the memory card to the camera. See "To add a memory card",
4.9.2 Storage Settings.
2. If you like to set up the pre-recording, post-recording or audio
recording, see 4.1.1 Video Settings.
3. If you like to set up the schedule for video recording or I/O monitoring,
see 4.6 Recording Schedule.
4. If you like to configure the areas and sensitivity values for motion
detection, see 4.1.2 Motion Detection.
5. If you want the recording to be triggered by input device, configure the
operation of input device. See 4.3.1 Input Settings.
6. To start recording and I/O monitoring, see 4.5 Monitoring.
The camera will start recording in case of motion detection, I/O trigger, or
during the scheduled time.
168