GeoVision GV-EBX1100 Series Firmware Manual page 181

[Disk Information]
Note this function is not supported for Target Series. This section shows
the details of the attached storage device. Use the Format/Remove button
to format or unload a storage device. For detail steps, see Partition
Information below.
[Partition Information]
Note this function is not supported for Target Series. This section shows
the partition details of the attached storage device.
To add a storage device:
1. Insert the storage device to the camera.
2. Click the Format button.
3. After the format is complete, the partition information will display. The
maximum space for one partition is 200 GB.
To remove a storage device:
1. Click the Remove button.
2. When you are prompted to ensure the action, click Yes. The page will
be refreshed and the partition information will be cleaned.
3. Remove the storage device from the camera.
The storage device status is indicated in the status column:
Status
Formatting
Unknown
OK
Try Mount
Error File System
160
Description
The storage device is being formatted.
The camera can not recognize the format of the
storage device or the device can not be found.
Storage formatting is successful.
The camera is attempting to connect to the storage
device.
There is a recording error in the storage device. All
the recording data is inaccessible under the status.