Advertisement
Step 25: Assemble Bean Bag Toss
Part 1
A: Place 1 (2838) Leg flush to 1 (2837) Diagonal as shown, note the board orientation. Pre-drill holes in (2838)
Leg using a 1/8" (3.2mm) drill bit and attach (2837) Diagonal using 2 (S4) #8 x 3" Wood Screws. Repeat step to
make a second assembly. (fig. 25.1)
B: In the location shown in (fig 25.3), place leg assemblies so that they sit on top of the bottom frame and to the
inside of the Post and Jamb making sure that all edges are flush. Attach (2837) Diagonals using 1 Hex Bolt (with
flat washer) per side and attach each (2838) Leg using 2 (S11) #8 x 2" Wood Screws per side. (fig. 25.2 & 25.3)
Fig. 25.1
2838
Fig. 25.3
Wood Parts
2 x
Diagonal 25.4 x 57.2 x 355.6mm
2837
2 x
Leg 25.4 x 57.2 x 164.8mm
2838
2837
S4
Flat Washer
Fig. 25.2
Hardware
2 x
Lag Screw 1/4 x 2-1/2"(with flat washer)
LS2
4 x
#8 x 2" Wood Screw
S11
4 x
#8 x 3" Wood Screw
S4
56
Flat Washer
LS2
x 2 per
S11
side
Flush
2837
2838
Advertisement
