Advertisement
Step 5: Swing End Assembly
A: Loosely attach 2 (2613) Heavy SW Posts to (2615) SW Upright using 2 (G7) 5/16 x 5-1/2" Hex Bolts (with
lock washer, flat washer and t-nut). Notice 2 bolt holes at top of (2615) SW Upright and orientation of angle.
(fig. 5.1)
B: Attach (2616) SW Support to both (2613) Heavy SW Posts and (2615) SW Upright using 3 (G4) 5/16 x 4"
Hex Bolts (with lock washer, flat washer and t-nut). Tighten all bolts. (fig. 5.1)
C: Install 2 (WB7) 5/16 x 3" Wafer Bolts (with flat washer and t-nut) in the top bolt holes in (2615) SW Upright
as shown in fig. 5.1. IT IS IMPORTANT THAT THESE BOLTS ARE ATTACHED. THEY WILL MINIMIZE
CHECKING OF WOOD.
Fig. 5.1
2613
Wood Parts
2 x
Heavy SW Post 50.8 x 76.2 x 2201.9mm
2613
1 x
SW Upright 76.2 x 76.2 x 1294.3mm
2615
1 x
SW Support 23.8 x 82.6 x 1181.1mm
2616
2616
TN2
FW2
LW2
G4
2 x
Hex Bolt (lock washer, flat washer, t-nut)
G7
3 x
Hex Bolt (lock washer, flat washer, t-nut)
G4
2 x
Wafer Bolt (flat washer & t-nut)
WB7
TN2
2615
Hardware
25
FW2
WB7
G7
FW2
LW2
Notice 2 bolt
holes at top and
orientation of
the angle
TN2
Advertisement
