Advertisement
Step 4: Swing Beam Assembly
A: Attach 6 Swing Hangers to the (2614) Engineered Beam using 2 (G7) Hex Bolts (with 2 flat washers and 1
lock nut) per Swing Hanger as shown in fig. 4.1.
B: Flush to the Fort End of (2614) Engineered Beam attach 2 L-Beam Brackets with 2 (G21) Hex Bolts (with 2
flat washers and 1 lock nut). (fig. 4.2)
C: Install 1 (WB7) Wafer Bolt (with flat washer and t-nut) in the middle bolt hole in (2614) Engineered Beam
as shown in fig. 4.3. IT IS IMPORTANT THAT THIS BOLT IS ATTACHED. IT WILL MINIMIZE CHECKING OF
WOOD.
D: Attach KidKraft Plaque to centre of (2614) Engineered Beam (over top of t-nut) using 4 (S18) #6 x 1" Wood
Screws. (fig. 4.4)
Fig. 4.1
Fort End
5/16"
Lock Nut
Fig. 4.2
Fort End
L-Beam
Bracket
Flush
L-Beam
Bracket
G21
Wood Parts
1 x
Engineered Beam 76.2 x 133.4 x 2235.2mm
2614
Swing Hanger x 6
2614
5/16" Flat
Washer
Fig. 4.3
5/16" Flat
Washer
5/16" Flat
Washer
12 x
G7
2 x
G21
1 x
WB7
4 x
S18
2614
G7
5/16"
T-Nut
2614
WB7
Hardware
Hex Bolt (5/16" flat washer x 2, 5/16" lock nut)
Hex Bolt (5/16" flat washer x 2, 5/16" lock nut)
Wafer Bolt (5/16" flat washer & 5/16" t-nut)
#6 x 1" Wood Screw
24
5/16" Flat
Washer
x 4
S18
Fig. 4.4
KidKraft Plaque
Other Parts
6 x Swing Hangers
2 x L-Beam Bracket
1 x KidKraft Plaque
5/16"
Lock Nut
5/16" Flat
Washer
Advertisement
