Advertisement
Step 8: Install Ground Stakes
A: In the 5 places shown in (fig.8.1) drive the Rebar Ground Stakes 13" (330mm) into the ground against outside
front corner of End Wall Assembly, on both (2607) Diagonals and both (2613) Heavy SW Posts. Be careful not to
hit the washer while hammering stakes into the ground as this could cause the washer to break off.
B: Attach ground stakes using 1 (S7) #12 x 2" Pan Screw per ground stake (fig. 8.2 and 8.3).
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth any
sharp edges from impact area and touch up with outdoor paint.
must be driven 13" (330 mm) into ground. Digging or driving stakes can
be dangerous if you do not check first for under-ground wiring, cables
or gas lines.
Fig. 8.1
2613
SEE FRONT COVER
FOR SAFETY CLEARANCE
MOVE FORT TO FINAL LOCATION PRIOR TO STAKING
FINAL LOCATION MUST BE LEVEL GROUND
Warning!
To prevent tipping and avoid potential injury, stakes
Front
2607
2607
End Wall
Hardware
5 x
Pan Screw
S7
28
Fig. 8.2
Fig. 8.3
S7
Rebar
Ground
Stake
Other Parts
5 x Rebar Ground Stake
End
Wall
S7
Rebar
Ground
Stake
Advertisement
