KidKraft BLOOMFIELD F29180 Installation And Operating Instructions Manual page 30

Step 10: Install Tower Gussets
A: On the Back Wall, place 2 (2850) Tower Gussets so they are flat against the Back Wall Panel. Attach using
1 (S11) #8 x 2" Wood Screw Wood and 1 (S4) #8 x 3" Wood Screw in the upper holes and 1 (LS3) 1/4 x 3" Lag
Screw (with flat washer) in the lower holes per Tower Gusset. (fig. 10.1 and 10.2) .
B: On the End Wall, place 2 (2850) Tower Gussets so they are flat against the End Wall Panel. Attach using 1
(S11) #8 x 2" Wood Screw Wood and 1 (S4) #8 x 3" Wood Screw in the upper holes and 1 (LS3) 1/4 x 3" Lag
Screw (with flat washer) in the lower holes per Tower Gusset. (fig. 10.1 and 10.2)
Note: Pre-drill with a 1/8"(3.2mm) drill bit before installing Lag Screw.
Fig. 10.1
9273
Wood Parts
4 x Tower Gussets 31.8 x 76.2 x 304.8mm
2850
2850
Back Wall
4 x
4 x
4 x
9272
2850
End Wall
Hardware
#8 x 3" Wood Screw
S4
#8 x 2" Wood Screw
S11
1/4 x 3" Lag Screw (with flat washer)
LS3
30
Fig. 10.2
Side View
S11
S4
LS3
Flat
Washer