Advertisement
**other gables hidden for clarity**
Step 19: Attach Roof Panels
Begin with two gable assemblies and assemble
Part 2
as shown
note: this hole
D: Take a second roof panel and fit the connector tabs so they are coupled with the panel that was previously
**other gables hidden for clarity**
not used
installed. Snap them into place and attach panels together using 2 (S2) #8 x 1-1/2" Wood Screws and then attach
**other gables hidden for clarity**
panels to (2852) Roof End using 3 (S11) #8 x 2" Wood Screws. (fig. 19.5, 19.6, 19.7 and 19.8)
Begin with two gable assemblies and assemble
as shown
Begin with two gable assemblies and assemble
as shown
* Other gables hidden for clarity
Begin with two gable assemblies and assemble as shown
**other gables hidden for clarity**
note: this hole
Begin with two gable assemblies and assemble
not used
Note: This hole
not used
as shown
Fig. 19.5
A
A
A
A
B
Fig. 19.7
S11
B
B
B
note: this hole
not used
S2
note: this hole
not used
make sure Roof End
is flush to groove
on panel
Make sure Roof End is
flush to groove on panel
make sure Roof End
is flush to groove
make sure Roof End
on panel
is flush to groove
on panel
make sure Roof End
is flush to groove
on panel
2852
6 x
2 x
2X #8 x 1-1/2" WS per roof
2X #8 x 1-1/2" WS per roof
2X #8 x 1-1/2" WS per roof
Hardware
#8 x 2" Wood Screw
S11
#8 x 1-1/2" Wood Screw
S2
44
2X #8 x 1-1/2" WS per roof
Fig. 19.6
Fig. 19.8
S11
3X #8 x 2" WS per roof
3X #8 x 2" WS per roof
3X #8 x 2" WS per roof
3X #8 x 2" WS per roof
S2
Advertisement
