Upgrading Mcu Firmware - Bolin Technology VCC-7HD20S-3SMC User Manual

Upgrading MCU Firmware

USB Firmware upgrade interface provides capability of constantly improving the camera features and
performances, even for customized function upgrades.
MCU Firmware can be upgraded by following these steps:
1. Load the .bin file onto a flash drive (Formatted as FAT32),
and name the file "HD20.bin"
2. With the camera powered off, insert the flash drive to the
USB port on the back panel of the camera
3. Apply power to the camera
The green indicator light above the lens will turn red for a few
seconds while the upgrade takes place. Once the upgrade is finished,
the light will turn green, and the camera will proceed through a
normal boot cycle. Check the data on the OSD boot screen
NOTE:
The firmware upgrade process is intended to be performed under the supervision of a BOLIN-Authorized repair
technician. For assistance with this, please contact your authorized BOLIN Technology dealer, installer, or integrator.
BOLIN Technology Technical Support can also be reached for assistance with this process
27