Cardinal Health AirLife nCPAP Hardware Service Manual page 18

Table of Contents

Federal (USA) law restricts this device to sale by or on the order of a

Do not block or occlude flow from exiting the Oxygen Sensor Bleed Port as

this may damage the internal oxygen sensor or create internal leaks.

Any liquid introduced into the gas supplies will cause malfunction of this

Always disconnect the machine from facility power, oxygen and medical air

To enhance patient safety and comfort, use only with heated humidifiers

and heated wire circuits. The recommended setting is 37 ºC, 100% RH.

To obtain maximum battery life, it is recommended that the driver remain

specified pressure range in order to pass the initial startup sequence. This

will enable the driver to perform a valid calibration and ensure accurate

physician or licensed practitioner.

driver and the equipment connected to it.

before performing any maintenance procedures.

connected to an external power source even when it is not in use.

The driver must have both gases properly connected and within the

AirLife

CAUTION

Note:

FiO

delivery.

Page 18 of 81

nCPAP Driver Service Manual

Table of Contents