Table of Contents
Advertisement
1 INTRODUCTION
8.
Selection of setting paramenter;
material thickness
NOTE!
The push button is also used for hidden functions, see section "Hidden TIG
functions".
Measured value in the display for welding current A, is arithmetic average value = rectified
average value.
1.3
Control panel TA34
1.
Knob for setting of current (A) or time (s)
2.
Display
3.
Selection of welding method; TIG
4.
Selection of TIG/MMA-welding with direct current
or TIG-welding with pulsed current
5.
Selection of start; HF start
6.
Selection of stroke; 2-stroke
7.
Setting from panel
or connecting remote control unit
8.
Display of VRD function (reduced open-circuit voltage); active or inactive
NOTE!
This function works for power sources where it is implemented.
0460 447 174
, slope down
or gas post flow
or MMA
™
or LiftArc
or 4-stroke
, welding data change with torch trigger switch
- 4 -
© ESAB AB 2018
Advertisement
Table of Contents
