Introduction; Control Panel - ESAB Caddy TA33 Instruction Manual

Hide thumbs Also See for Caddy TA33:

Table of Contents

INTRODUCTION

The manual describes the use of TA33, TA34 control panel.

For general information about operation see instruction manual for the power source.

When mains power is supplied the unit runs a self diagnosis of the

LEDs and the display, the program version is displayed and in this

example the program version is 0.18.

1.1

Control panel TA33

Knob for setting data (current (A), time (s) or material thickness (mm/inch))

Display

Choice of welding method TIG

Choice of selection of HF start

Choice of 2--stroke

Display of VRD function (reduced open- -circuit voltage) is active or inactive.

NOTE! This function is not yet fully supported.

Indication of which parameter is shown in the display, current (A), time (s) or

material thickness (mm/inch)

Choise for selection of setting parameter,

material thickness

Note! The pushbutton is also used for hidden functions, see on page 23.

bi19d2ea

or MMA

or LiftArct start

or 4--stroke

, slope down

or gas post flow

- - 17 - -

Table of Contents

Show Quick Links

Table of Contents

Caddy ta34