1 INTRODUCTION
1
INTRODUCTION
1.1
Overview
The manual describes the use of TA33 and TA34 control panel.
For general information about operation see the Instruction manual for the power source.
When the mains power is supplied the unit runs a self diagnosis of the LEDs
and the display, the program version is displayed and in this example the
program version is 0.18.
NOTE!
Differencies in the panel function may occur, depending on in which product it is
installed.
1.2
Control panel TA33
1.
Knob for setting data; current (A), time (s) or material thickness (mm/inch)
2.
Display
3.
Selection of welding method; TIG
4.
Selection of start; HF start
5.
Selection of stroke; 2-stroke
6.
Display of VRD function (reduced open-circuit voltage); active or inactive
NOTE!
This function works for power sources where it is implemented.
7.
Indication of which parameter is shown in the display; current (A), time (s) or material
thickness (mm/inch)
0460 447 174
or MMA
™
or LiftArc start
or 4-stroke
- 3 -
© ESAB AB 2018