Table of Contents
Advertisement
2 TIG WELDING
4-stroke
In 4-stroke mode, press the TIG torch trigger switch (1) to start shielding gas flow
and initiate the arc at a pilot level. Release the trigger switch (2) to slope up the
current to the set current value. To stop the welding, press the trigger switch again
(3). The current will slope down to the pilot level again. Release the trigger switch (4)
to terminate the arc. The shielding gas will continue to flow in order to protect the
weld and the tungsten electrode.
A = Gas pre flow
B = Slope up
Material thickness
The current is set automatically due to material thickness (mm/inch).
To increase or decrease the current, push on
slope down and gas post flow no longer are active and set the current.
Gas post-flow
This controls the time during which shielding gas flows after the arc is
extinguished.
Active panel
Settings are made from the control panel.
Changing trigger data
This function permits changing between different welding data memories by a
double press on the trigger of the welding gun. Only applies for TIG welding.
Remote control unit
Settings are made from the remote control unit.
The remote control unit must be connected to the remote control unit socket on
the equipment before activation. When the remote control unit is activated the
panel is inactive.
2.3
Hidden TIG functions
There are hidden functions in the control panel.
0460 447 174
C = Slope down
D = Gas post flow
until the symbols for material thickness,
- 10 -
© ESAB AB 2018
Advertisement
Table of Contents
