Initializing The Scanner To Factory Defaults - GRE 0716 Owner's Manual

1. Turn off the scanner, then turn it on again. The scanner briefly
displays the DSP boot version, and then the Welcome/Owner
screen is displayed.
2. Press
screen. The scanner displays
System Tests:
Select a Test...
Exits if no key
is pressed
3. Press
Init GLOB data
To factory state
ENTER if APPROVE
CLEAR to EXIT
4. Press
GLOB EEPROM area
Initialized to
defaults.
Press any key.
5. Press any key on the keypad to proceed. The scanner will
reboot with file system and global parameters reset to factory
defaults.

Initializing the Scanner to Factory Defaults

If initializing the global parameters to factory defaults does not
resolve your problem, you may wish to initialize the entire
scanner to factory defaults. This operation will result in the
clearing of your programmed data and the loss of any custom
changes you have made to the radio s global parameters. Use
this option as a last result, and, if possible, save your working
memory to a V-Scanner folder prior to performing this operation.
NOTE: This procedure clears all information you stored in the scanner s working
memory, AND resets the global parameters to factory defautls. Initialize the
scanner only when you are sure the scanner is not working properly.
V-Scanner memory is not affected when the scanner is initialized.
1. Turn off the scanner, then turn it on again. The scanner briefly
displays the DSP boot version, and then the Welcome/Owner
screen is displayed.
0716 User Manual
while the scanner is displaying the Welcome/Owner
0
. The scanner displays
2
. The scanner displays
ENT
Page 95