GRE 0716 Owner's Manual page 72

Operation of the dedicated Spectrum Sweeper mode is almost
identical to that of the object mode, with one exception. When
running the Spectrum Sweeper as a Scannable Object, you must
use the object menu to enable or disable the Spectrum Sweeper
sub-bands when operating in Scan Mode. When dedicated
Spectrum Sweeper mode is used, you may press the numeric
key on the keypad that corresponds with the sub-band you wish
to enable or disable. Disabling a sub-band will cause the
Spectrum Sweeper system to skip the frequencies within that
sub-band as it performs its sweeps. The sub-bands are defined
as follows:
0: 25-54 MHz
1: 108-137 MHz
2: 137-174 MHz
3: 216-300 MHz
4: 300-406 MHz
5: 406-470 MHz
6: 470-512 MHz
7: 764-806 MHz
8: 806-869 MHz
9: 896-1300 MHz
In Public Safety, the sub bands are defined as follows:
0716 User Manual
VHF Low Band
VHF Aircraft Band
VHF High Band
220 MHz Commercial/Amateur Band
UHF Military Air Band
UHF Band
UHF-T Band
700 MHz Band
800 MHz Band
900 MHz Band, 23 cm Amateur Band
Page 72