GRE 0716 Owner's Manual page 112

SWPR
Parameter
LED Color
Latch LED
Backlight
Alarm
Fav
EXPERT BELOW
Atten
Delay
Delay Time
Zeromatic
Special
Search Dir
Hit Count
0716 User Manual
Options
0-7
On or Off
On, Off or Flash
None, Chirp, Hi-Lo, Alert,
Ring, 2-Chirp, Fast Hi-Lo,
DTMF#
On or Off
On or Off
On or Off
1-200
On or Off
On or Off
Up or Down
Numeric value
Description
Sets LED color to 0-7 as defined in the GLOB
menu. By default, 0=LED Off, 1=Red, 2=Yellow,
3=Green, 4=Cyan, 5=Blue, 6=Magenta, 7=White.
Normally the ALERT LED is active only while the
object is receiving a transmission. When Latch is
on, the ALERT LED will remain lit after the
transmission is complete, unless overridden by a
subsequent object that is also using the ALERT
LED.
Controls whether the backlight should be on, off or
flashing while the object is active.
Sets the Audible Alarm for the SWPR object. When
an Audible Alarm is selected, the selected alarm will
play anytime the scanner stops for activity on the
SWPR object while scanning.
When On, the SWPR object is a member of the
Favorites Scan List.
When on, applies 20 dB of attenuation to all hits
received on the SWPR search. Useful in areas
where interference from nearby strong signals is
present.
Controls whether a Delay is used to wait for reply
traffic after a transmission on the SWPR search.
Sets the amount of time (in 100 millisecond
intervals) for the wait for reply delay if Delay is On,
e.g., 20=2 seconds.
When on, enhances the scanner s ability to lock on
to the actual center frequency of a search hit
instead of an adjacent frequency.
SWPR works by quickly sweeping the RF spectrum
in 1 MHz increments to find nearby strong signals.
If the 1 MHz sweep indicates that activity is present
in the 1 MHz range, SWPR sweeps that range to
find the source.
Sets search direction used when SWPR object is
active.
Increments each time a transmission is received on
the SWPR object. Global "Hit Counts" must be set
to ON. Press the Dflt softkey to reset to 0.
Page 112