Table of Contents
Advertisement
Basic CCDump data includes the system type, the Object ID of
the TSYS object (if applicable), and the "raw" control channel
messages as they are transmitted by the system. This data is
delimited by ":" symbols. Basic CCDump data is sent to the PC/
IF port under the following conditions:
• In TUNE mode, when the radio is tuned to a trunking control
channel
• In TSYS analysis mode, when the radio is tuned to an active
control channel in the TSYS channel list
Expanded CCDump data includes all of the data that is provided
in the Basic CCDump data display, and provides additional
human-readable decoding of certain trunked control channel
messages. Expanded CCDump data is sent to the PC/IF port
under the following condition:
• When the radio is monitoring a trunked control channel while in
MAN or SCAN modes
The following describes the CCDump message format for the
supported modes:
<Msg Type>:T<xxxx>:<CC data>[:<Expanded CCDump description>]
<Msg Type>= always 3 ASCII chars:
<xxxx>
<CC data> = the "osw" from the CC. The format necessarily
0716 User Manual
WXS (WX SAME)
WXT (WX 1050Hz tone)
P25, M36, LTR, EDW, EDN
= the hexadecimal representation of the TSYS's File
System ID (for WXS and WXT, this is the current Wx
Chan 0-6, if in TUNE mode, "AAAA")
depends on the system type:
P25:
<X1><X2><X3><X4><X5><X6><X7><X8><X9><XA><XB><XC>
<X1> - <XC> = 12 2-digit hexadecimal bytes
from the last msg
M36:
<cmd> <dir> <id>
<cmd> = 3-digit (10-bit) hex "command" value
<dir> = direction bit
<id>
= 4-digit (16-bit) hex "id" value
LTR:
<RR>: <A>-<GG>-<HH>-<III>-<FF>
<RR>
= repeater on which the msg was received
<A>
= area
<GG>
= Goto/In-Use repeater #
<HH>
= Home Repeater #
<III> = Group ID
Page 121
Advertisement
Table of Contents
