Changing The Display Contrast; Cloning The Programmed Data; Resetting/Initializing The Scanner - GRE PSR-295 Owner's Manual

To turn off the key lock, press and hold KEY about 3 sec-
onds. The scanner beeps three times and Key unlocked.
appears.

Changing the Display Contrast

1. Press MANUAL.
2. Press FUNC then 9. Use Up/Down keys to set contrast,
Enter key saves. appears.
3. Press /\ or \/ to select the contrast.
4. Press ENTER to set the display contrast.

Cloning the Programmed Data

You can transfer the programmed data to and from an-
other PSR-295 scanner using an optional connecting
cable with 3.5mm phone plugs on both ends (not sup-
plied).
Note: ** CLONE MODE ** Incorrect Model! appears if
the scanner receives data from another scanner other
than a PSR-295.
Follow these steps to clone the data.
1. Turn on both scanners.
2. Connect the connecting cable to each scanner's PC/
IF jack. ** CLONE MODE ** Press UP to send Remove
cable to exit. appears.
3. Press /\. Confirm send data? 1 -> YES Press other key
for NO. appears.
4. Press 1 to send the data to the other unit or press any
other key to cancel the operation.
The scanner sends the data. To exit the clone mode, re-
move the cable.
RESETTING/INITIALIZING THE
SCANNER
If the scanner's display locks up or does not work prop-
erly after you connect a power source, you might need to
reset or initialize it.
34
Page 34 2004/07/06, 15:37