GRE 0716 Owner's Manual page 66

will allow you to monitor traffic from any tower that you are within
range of.
To activate Multi-site mode on a Motorola or P25 networked
system, follow these steps:
Press , then navigate to a talkgroup on the networked multi-
PGM
site system using the keys.
Press the EDIT softkey, then press the CURR softkey.
Scroll down to the TSYS item and press the
key to edit the
SEL
TSYS parameters.
Scroll to Multi-Site. Use the keys to select Off, Stat
or Roam. When set to Off, the scanner will find the first usable
control channel in the control channel list and use it until it is no
longer usable. When set to Stat(ionary), the scanner will track
the system using any control channel in the list that is usable.
When set to Roam, the scanner will attempt to locate and use the
best possible control channel and ignore others, until the control
channel is no longer usable, then it will locate a new "best control
channel" to use. When Multi-Site=ROAM, the scanner will
always attempt to lock on to control channels where the
decoding quality is greater than the Threshold Hi setting, and will
search for new control channels when the decoding quality of a
control channel drops below Threshold Lo setting, and, if no new
control channels are available that meet the Threshold Hi criteria,
the scanner will seek the best control channel to use, and
continue checking periodically for a new control channel that
meets the Threshold Hi criteria. When Multi-Site=STAT, the
scanner will track the system using every usable control channel
in the control channel list.
Press the SAVE softkey to save your changes to the TSYS
parameters, then press the SAVE softkey again to use the
scanner.
You should experiment with the different Multi-site modes and
the threshold settings to find a combination that works best for
your location. Keep in mind that the threshold settings are only
available when Multi-Site Roam is selected.
Multi-site functionality is not available in EDACS or LTR trunking.
0716 User Manual Page 66