ICP DAS USA tM-7565 User Manual page 36

The uart to can bus converter

Hide thumbs Also See for tM-7565:

Table of Contents

Check the "Active Port" and Click "Confirm" button to enable the CAN port of the CAN

converter. The parameters set here are not stored in the EEPROM. If users would like to

configure the other parameters expect the CAN parameters, please use Configuration

interface of the VxCAN Utility to do that.

 Step 6. Click "Start" button

The test interface is divided to two areas. One is for sending CAN messages, and the

other is for reception. If users want to send CAN message, fill the data into the

corresponding field, and click "Send" button. If the CAN converter gets any CAN

messages, they will be shown in received area automatically. About the details for the

VxCAN Utility operation please refer to the users' manual of the VxCAN Utility in the

following web site.

http://ftp.icpdas.com/pub/cd/fieldbus_cd/can/virtual_can/vxcan_utility/

I-7530, I-7530-FT, I-7530A, I-7565, tM-7530, tM-7530A, tM-7565 User Manual Version 1.5

to open test interface.

Send Area

Received Area

E-mail: service@icpdas.com

Page：

Table of Contents

I-7530t I-7530-ft I-7530a I-7565 Tm-7530 Tm-7530a ... Show all