ICP DAS USA tM-7565 User Manual page 32

The uart to can bus converter

Hide thumbs Also See for tM-7565:

Table of Contents

CAN network.

 Pair Connection Mode: When uses choose the Pair Connection in the Communication

Mode, the pair connection configuration field will be presented.

＊ Fixed CAN ID: Set the fixed CAN ID for the transmitted UART data to the CAN network.

Each CAN converter must have different configuration of the fixed CAN ID. If there are

more than one CAN converter in the pair connection mode, the same fixed CAN ID will

make the CAN ID conflict error while these CAN converter are transferring the UART

data to the CAN message at the same time.

＊ Response with CAN ID: Users can decide if the CAN ID needs to be transmitted with

the UART data to the UART interface. In the pair connection application (see the picture

of the section 1), the CAN ID always doesn't need to be send to the UART interface.

＊ End Characters of UART Commands: This function is used to set the end characters

of the UART command received by the CAN converter. The UART data transferred from

the CAN messages will not append the specific end characters. If the CAN converter

gets the specific end characters from the UART interface, it is regarded as the end of the

UART command, and the CAN converter will start to transfer the UART command to the

CAN messages immediately.

I-7530, I-7530-FT, I-7530A, I-7565, tM-7530, tM-7530A, tM-7565 User Manual Version 1.5

E-mail: service@icpdas.com

Page：

Table of Contents

I-7530t I-7530-ft I-7530a I-7565 Tm-7530 Tm-7530a ... Show all