ICP DAS USA tM-7565 User Manual page 35

The uart to can bus converter

Hide thumbs Also See for tM-7565:

Table of Contents

Test Interface:

 Step 1. Set the Init/Normal DIP switch of the CAN converter to normal mode, see the

section 2.5.1. When the CAN module runs on the normal mode, the run LED indicator will

be turned on. If the CAN converter sends or receives the CAN messages, the run LED will

flash once per message.

 Step 2. Connect the COM port of PC to the CAN converter, and execute the VxCAN Utility.

 Step 3. Click the search button



Step 4. Afterwards, the searched CAN modules are listed in the left window of the VxCAN

Utility



Step 5. Click the CAN port of the CAN converter to set the CAN parameters of the CAN

converter.

I-7530, I-7530-FT, I-7530A, I-7565, tM-7530, tM-7530A, tM-7565 User Manual Version 1.5

to search all CAN converters connected to the PC.

E-mail: service@icpdas.com

Page：

Table of Contents

I-7530t I-7530-ft I-7530a I-7565 Tm-7530 Tm-7530a ... Show all