Chapter 5. Configuring Your Ethernet Connection; Requirements; How To Use This Chapter; Tcp/Ip Configuration For Windows Xp - Arris Touchstone TG2492S/CE User Manual

Configuring Your Ethernet Connection
If your computer is equipped with a LAN card providing an Ethernet connection, you may
have to configure your computer's TCP/IP settings. The steps that follow will guide you
through setting your computer's TCP/IP settings to work with the Telephony Gateway.

Requirements

Make sure you have the following before attempting to configure your Ethernet
connection:
Computer with Ethernet interface

Ethernet cable (supplied)

IP address, subnet, gateway, and DNS information for installations not using DHCP


How to use this Chapter

The following list shows the procedures for modifying the TCP/IP settings on the
computer. The procedure is slightly different depending on the operating system that you
are using. Please ensure you are using the correct steps for the operating system on your
computer. Follow the links below for instructions to configure your Ethernet connection on
your operating system.

TCP/IP Configuration for Windows XP


TCP/IP Configuration for Windows Vista

TCP/IP Configuration for Windows 7 or Windows 8

TCP/IP Configuration for MacOS X

TCP/IP Configuration for Windows XP
Follow these steps to configure the Ethernet interface on a Windows XP operating system.
TCP/IPv6 Note: This procedure shows the configuration of TCP/IPv4. TCP/IPv6 is not
installed or enabled by default in Windows XP. If your cable provider requires TCP/IPv6
you must first install and enable it on your Windows XP system. Refer to Microsoft support
Release 24 STANDARD 1.1 March 2015
Copyright ARRIS Enterprises, Inc. 2015. All Rights Reserved.
(page 28)
(page 29)
(page 30)
(page 30)
Touchstone TG2492 Telephony Gateway User Guide 28
Chapter 5