Smtp Settings - ATEN KM0932 User Manual

SMTP Settings

The KM0032 / KM0532 / KM0932 can send reports from an SMTP server. To
have the KM0032 / KM0532 / KM0932 email reports from the SMTP server
to you, do the following:
1. Click to put a check in the Enable report from the following SMTP server
checkbox.
2. Key in either the domain name or the IP address of your SMTP server.
3. If your server requires authentication, click to put a check in the My server
requires authentication checkbox.
4. Key in the appropriate account information in the Account Name,
Password, and From fields.
Note: Only one email address is allowed in the From field.
5. Key in the email address (addresses) of where you want the report sent to
in the To field.
Note: If you are sending the report to more than one email address,
separate the addresses with a semicolon.
When you have finished making your ANMS page settings, click Save.
 Log Server
Important transactions that occur on the switch, such as logins and internal
status messages, are kept in an automatically generated log file.
 Specify the MAC address of the computer that the Log Server runs on
in the MAC address field.
 Specify the port used by the computer that the Log Server runs on to
listen for log details in the Port field. The valid port range is 1–65535.
The default port number is 9001.
 Syslog Server
To record all the events that take place on the switch and write them to a
Syslog server, do the following:
1. Check Enable.
2. Key in either the IPv4 address or domain name of the Syslog server.
 Key in the port number. The valid port range is 1-65535.
Chapter 6. Device Management
55