Example 1 - Normal Scan; Example 2 - Specific Scan - ATEN KM0932 User Manual

KM0032 / KM0532 / KM0932 User Manual
AS
This command is used to enabled Auto Scan Mode for a console. The generic
format of this command is:
AS XX YY ZZ
Where:
 XX is a two-digit number that represents the console number on the
KM0032 / KM0532 / KM0932 you want Auto Scan Mode started.
 YY represents the scan duration in seconds that Auto Scan Mode will pause
for between each port scan.
 ZZ is a two-digit number that represents the port(s) on the switch that you
want to scan. When ports are specified in Auto Scan Mode, those ports are
scanned, and all other ports are ignored.
Example 1 – Normal Scan:
To start Auto Scan Mode on console 02, to scan all ports, issue the following
command:
AS 02
This command sets console 2 to start auto scanning all ports, with the Scan
Duration time set in Port Access - Preferences.
Example 2 – Specific Scan:
AS 02 03 02,05,08,09,10,12
This command starts Auto Scan Mode for console 02, at 3 second scan
intervals, on ports 02, 05, 08, 09, 10, and 12.
This command enables Auto Scan Mode on console (XX), for a specific scan
duration (YY), on the ports specified (ZZ,ZZ). All other ports are ignored.
ST
This command is used to disable Auto Scan Mode for a console. The generic
format of this command is:
ST XX
Where: XX is the console number on which you want Auto Scan Mode
disabled.
168