Terminal Descriptions - Parker 514C Product Manual

2-2
Pre-Installation Planning

TERMINAL DESCRIPTIONS

Control Terminals
TERMINAL FUNCTION
T1 Tacho Feedback
T2 Not Connected
T3 Speed Meter Output Analogue Output,
T4 DO NOT USE
T5 Run Input
T6 Current Meter
Output
T7 Torque/Current
Limit Input
T8 0V Common
T9 Setpoint Ramp
Output
T10 Positive Trim Speed
Setpoint Input
T11 0V Common
T12 Total Setpoint Sum
Output
T13 Setpoint Ramp Input Analogue Input,
T14 +10V Reference
Output
T15 Stall Override Input Digital Input to Override Stall Detection
T16 -10V Reference
Output
T17 Negative Trim
Speed Setpoint
Input
DESCRIPTION
Motor Mounted Tachogenerator Input.
Proportional to Motor Speed.
0 to 10V for 0 to 100% Speed.
Pending Change.
Digital Input to Run Controller.
+24V to Run.
0V to Stop.
Analogue Output, 0 to +7.5V =
150% Calibrated Current
SW1/5 Off = Bipolar
SW1/5 On = Magnitude
Analogue Input,
0 to +7.5V = 0 to 150% of Calibrated
Current.
Analogue / Digital Signal Common
Analogue Output,
0 to 10V = 0 to 100% Ramped
Setpoint.
Analogue Input,
0 to 10V = 0 to 100% Speed.
Analogue / Digital Signal Common.
Analogue Output,
0 to 10V = 0 to 100% Speed.
0 to +10V = 0 to 100% Forward
Speed.
0 to -10V = 0 to 100% Reverse Speed.
Analogue Output,
+10V Reference for Speed/ Current
Setpoints.
+10V = Override.
Analogue Output,
-10V Reference for Speed/ Current
Setpoints.
Analogue Input,
0 to +10V = 0 to 100% Reverse Speed
0 to -10V = 0 to 100% Forward Speed.
NOTES
+350 Vdc Max. Approx
220 kohm.
5mA output
S/C protected
5mA output
S/C protected
approx.
100 kohm
5mA output
S/C protected
approx.
100 kohm
5mA output
S/C protected
approx.
100 kohm
5mA output
S/C protected
approx.
100 kohm
5mA output
S/C protected
approx.
100 kohm
514C Product Manual