Memory Card Storage - Bolin Technology SD500 Series User Manual

here, so that the camera can receive alarm information from the third-party alarm input device.
4. Set actions to be triggered by an input alarm and the plan. For the detailed steps, see the descriptions
of alarm-triggered actions in Configuring Motion Detection Alarm .
5. Click Save.
Configuring Alarm Output
After alarm output is triggered by a motion detection alarm, temperature alarm or Boolean alarm, the camera can
output alarm information to the third-party device if alarm output is set correctly to Normally Open or Normally
Closed. The alarm output duration is configurable.
1. Click Setup > Events > Alarm Output.
2. Select the alarm and set the alarm name. Set the
status to Normally Open (default setting) and set the
alarm duration.
3. Click Save.
CAUTION:
Strictly follow the sequence when powering on the devices to avoid damaging camera components:

Check that the alarm type is set to Normally Open (default setting), and that the camera and the alarm output
device are powered off.

After completing the connection, power on the alarm output device first and then power on the camera.
Configuring Capture
With the function of capture configured, when an alarm is triggered, the camera will automatically upload the
captured snapshots to the FTP server or send snapshots the specified email address.
1. Click Setup > Events > Capture.
2. Enable Capture, and configure relevant parameters.
3. Click Save.

Memory Card Storage

NOTE:

This function is not supported by some models, and may vary with models, please see the actual model for
details.

Memory storage is recommended when the camera operates in stand-alone mode.
Memory card storage is used to save videos and snapshots to the memory card directly.
Manual storage
The camera records live video repeatedly if manual storage is enabled.
1. Click Setup > Storage > Storage.
39