Table of Contents
Advertisement
2.
Select Enable for NTP, and then enter the IP address of the NTP server and the camera's sync interval
with the NTP server.
3.
Click Save. The camera will periodically synchronize time with the NTP server.
Setting Servers
If the camera is managed by a central server, you need to configure the server related parameters.
CAUTION:
This function is not supported by some models, please see the actual model for details.
If the device ID, protocol or server IP is changed, the camera will restart, and the login password for admin and
the system time will be updated as the settings on the central management server. In addition, all settings, except
the following, will be restored to factory defaults: network interface card, server, image, OSD, privacy mask,
custom information, and ROI.
Registration will fail if the device ID is different from that stored on the central management server. You need to
restart the camera in order for the registration to succeed.
If the camera operates independently, select None for Protocol.
Connect via the Private protocol
1. Click Setup > Common > Server, and
then click the Management Server tab.
2. In the Device ID text box, enter an ID
that is unique in the network.
3. Select Private from the Protocol drop-
down list.
4. Enter the correct IP address and port
number for the central management
server.
5. Click Save.
Serial Port Mode Configuration
The RS485 serial port is used for data exchange with the third-party device. Serial port settings on the camera
should be consistent with that of the connected third-party device.
NOTE:
This function is not supported by some models, please see the actual model for details.
The actual displayed Web interface may vary with the device model.
43
Advertisement
Table of Contents
