Memory Card Storage; Configuring Alarm Output - Bolin Technology EX1030BHD-L5NA User Manual

Configuring Alarm Output

After alarm output is triggered by a motion detection alarm, temperature alarm or Boolean alarm, the camera can output
alarm information to the third-party device if alarm output is set correctly to Normally Open or Normally Closed. The
alarm output duration is configurable.
1. Click Setup > Events > Alarm Output.
2. Select the alarm and set the alarm name. Set the status
to Normally Open (default setting) and set the alarm
duration.
3. Click Save.
CAUTION:
Strictly follow the sequence when powering on the devices to avoid damaging camera components:
•
Check that the alarm type is set to Normally Open (default setting), and that the camera and the alarm output
device are powered off.
•
After completing the connection, power on the alarm output device first and then power on the camera.
Configuring Capture
With the function of capture configured, when an alarm is triggered, the camera will automatically upload the
captured snapshots to the FTP server or send snapshots the specified email address.
1. Click Setup > Events > Capture.
2. Enable Capture, and configure relevant parameters.
3. Click Save.

Memory Card Storage

NOTE:
•
This function is not supported by some models, and may vary with models, please see the actual model for details.
•
Memory storage is recommended when the camera operates in stand-alone mode.
Memory card storage is used to save videos and snapshots to the memory card directly.
Manual storage
The camera records live video repeatedly if manual storage is enabled.
1. Click Setup > Storage > Storage.
2. Enable memory card storage and modify the settings as required. The following table describes some major
parameters.
41