Configuring Parameters
Local Parameters
Set local parameters for your PC.
NOTE:
The local parameters may vary with models, please see the actual Web interface for details.
Select Setup to go into IP camera setting up menu.
1. Select Setup > Common > Basic Info.
It displays the basic information of the camera.
2. Select Setup > Common > Local Settings.
3. Modify the settings as required. The following table
describes some major parameters.
A. Video Alarm
a. Processing Mode
i. Real Time Prior: Recommended if the
ii. Fluent Prior: Recommended if you want short time lag for live video.
iii. Ultra-low Delay: Recommended if you want the minimum time lag for live video.
b. Video Pixel Format
i. Set the video format for images on the PC client.
c. Protocol
i. Set the protocol used to transmit media streams to be decoded by the PC.
B. Record and Snapshot
a. Recording
i. Subsection By Time: Duration of recorded video for each recording file on the computer. For
network is in good condition.
It is recommended to choose YUV420 if the graphic card of your PC supports it. RGB32 is only
supported by some low-version graphic cards.
20