Table of Contents
Advertisement
Available commands are listed below.
C
Configure the idle timeout settings for automatically terminating a console-connected
session if no input is made.
Press "C." The command prompt changes to "Enter console idle timeout>." Enter a
value from 0 to 60 (minutes). Entering "0" disables the automatic termination.
T
Configure the idle timeout settings for automatically terminating a Telnet-connected
session if no input is made.
Press "T." The command prompt changes to "Enter telnet idle timeout>." Enter a
value from 1 to 60 (minutes).
N
Edit the login user name.
Press "N." The command prompt changes to "Enter current password>." Enter the
current password. After entering the correct password, the command prompt
changes to "Enter new name>." Enter a new user name in 12 one-byte characters.
P
Edit the login password.
Press "P." The command prompt changes to "Enter old password>." Enter the
current password. After entering the correct password, the command prompt
changes to "Enter new password>." Enter a new password in 12 one-byte
characters. After entering the password, the command prompt changes to "Retype
new password>" for confirmation. Enter the new password again.
L
Configure the Telnet access settings.
Press "L." The command prompt changes to "Enable or Disable telnet server(E/D)>."
Press "E" to enable the access. Press "D" to disable the access.
S
Configure the SNMP access settings.
Press "S." The command prompt changes to "Enable or Disable SNMP
Agent(E/D)>."
Press "E" to enable the access. Press "D" to disable the access.
Y
Configure the Syslog transmission settings.
Press "Y." The command prompt changes to " Enable or Disable Syslog Transmission
(E/D)>."
Press "E" to enable the function. Press "D" to disable the function.
R
Configure the RADIUS server access settings for login authentication.
Press "R." The RADIUS Configuration Menu opens. For configuration details, refer
to the next section (4.6.7.c).
M Configure the action after failed to authenticate for Method 1.
Press "M." The command prompt changes to " Enter Method 1 Fail Action (M/S)>."
Press "M" to use Method 2. Press "S" to stop authenticating.
G
Set Syslog transmission.
Press "G." The Syslog Transmission Configuration Menu opens. For configuration
details, refer to the next section (4.6.7.e).
A
Set Telnet accessible terminals.
Press "A." The Telnet Access Limitation Menu opens. For configuration details, refer
to the next section (4.6.7.a).
I
Configures the access settings for the IP address configuration software, bundled with
the Panasonic network cameras.
Press "I." The command prompt changes to "Enable or Disable IP setup interface
(E/D)>."
Press "E" to enable the access. Press "D" to disable the access.
O
Set the verification method of the login user name and password.
87
Advertisement
Table of Contents
