Table of Contents
Advertisement
4.6.7.h. LED Base Mode Configuration
On the System Security Configuration, pressing "B" opens the LED Base
Mode Configuration screen, as shown in Fig. 4-6-32. On this screen, you can
configure the LED base mode setting.
PN28080i Local Management System
System Security Configuration -> LED Base Mode Configuration
System LED base-mode: Status
Note: Save Configuration to Flash will be executed when LED Base Mode changed.
-------------------------------- <COMMAND> -----------------------------------
Set LED [B]ase Mode
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Fig. 4-6-32 LED Base Mode Configuration
Screen Description
System LED
Shows the current LED base mode.
base-mode
This is set to the status mode (Status) on shipment.
Status
Eco
Available commands are listed below.
B
Change the LED base mode.
Press "B." The command prompt changes to "Select LED Base Mode (S/E)>." Press "S"
to change the LED base mode to the status mode. Press "E" to change it to the ECO
mode.
Q
Return to the previous menu.
Note: If the LED base mode is changed, the configuration information is
saved and all settings are stored in a built-in memory.
Operating in status mode.
Operating in ECO mode.
101
Advertisement
Table of Contents
