Table of Contents
Advertisement
Community
Available commands are listed below.
S
Enable/disable the trap receiver.
Press "S." The command prompt changes to "Enter manager entry number>."
Enter an entry number for the trap receiver you wish to configure. Then, the
command prompt changes to "Enable or Disable Trap Receiver (E/D)>." Press "E"
to enable the SNMP manager. Press "D" to disable it.
I
Set an IP address for the trap receiver.
Press "I." The command prompt changes to "Enter manager entry number>."
Enter an entry number for the trap receiver you wish to configure. Then, the
command prompt changes to "Enter IP address for trap receiver>." Enter an IP
address.
D
Configure the trap sending settings when the link status changes.
Press "D" to open the Enable/Disable Individual Trap Menu.
For configuration details, refer to 4.6.3.C.
T
Set a trap type.
Press "T." The command prompt changes to "Enter manager entry number>."
Enter an entry number for the trap receiver you wish to configure. Then, the
command prompt changes to "Enter the selection>." Press "1" to select SNMPv1
traps. Press "2" to select SNMPv2 traps.
C
Set a community name for the trap receiver.
Press "C." The command prompt changes to "Enter manager entry number>."
Enter an entry number for a trap receiver you wish to configure. Then, the
command prompt changes to "Enter community name for trap receiver>." Enter
a community name.
P
Configure the IPv6 Trap Receiver settings.
Press "P." The IPv6 Trap Receiver Menu opens. For configuration details, refer to
4.6.3.o.
Q
Return to the previous menu.
Shows the current community name of a trap receiver.
71
Advertisement
Table of Contents
