Panasonic PN28080i-ID Operation Manual page 156

4.7.5.a. Traffic Class Configuration Menu
On the Quality of Service Configuration Menu, pressing "T" opens the Traffic
Class Configuration screen, as shown in Fig. 4-7-22. On this screen, you can
configure the traffic class setting.
PN28080i Local Management System
Quality of Service Configuration -> Traffic Class Configuration Menu
QoS Status: Disabled
Priority Traffic Class
-------- -------------
0
1
2
3
4
5
6
7
-------------------------------- <COMMAND> -----------------------------------
[S]et QoS Status
Set Priority-Traffic Class [M]apping
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Fig. 4-7-22 Traffic Class Configuration Menu
Screen Description
QoS Status
Priority
Traffic Class
Available commands are listed below.
S Set the status of QoS function.
Press "S." The command prompt changes to "Enable or Disable QoS (E/D)>." Press
"E" to enable the function. Press "D" to disable it.
M Assign a priority level (traffic class) to a priority value of IEEE802.1p.
Press "M." The command prompt changes to "Enter Priority (E/D)>." Enter a priority
value (0 to 7) to be assigned. Then, the command prompt changes to "Enter traffic
class for priority #>." Enter a priority level (traffic class) to be controlled by this
Switching Hub with a value of 0 to 3.
Q Return to the previous menu.
0
0
1
1
2
2
3
3
Shows the status of QoS function using IEEE802.1p.
Enabled QoS is enabled.
Disabled QoS is disabled. (Factory default setting)
Shows the priority value in a VLAN tag.
Shows the QoS priority level.
156
0: Lowest
7: Highest