Table of Contents
Advertisement
Screen Description
Accept RADIUS
Displays whether or not to use the Attribute reported from the
Attribute
RADIUS server.
The target Attribute is as follows.
Enabled
Disabled
Port
Displays the port number.
Current PVID
Displays the current PVID.
Auth Status
Displays the current port authentication status.
Authorized
Unauthorized
Guest
Displays the VLAN ID of the guest VLAN.
Specify a VLAN to be assigned while a client connected to the
authorized port is not authorized.
Default
Displays the VLAN ID of the default VLAN.
Specify a VLAN to be assigned when Accept RADIUS Attribute is
Enabled and Tunnel-Private-Group-ID is not reported from the
RADIUS server.
Available commands are listed below.
N
Display the next page.
Press "N" to display the next page.
P
Display the previous page.
Press "P" to display to the previous page.
A
Set whether or not to use the Attribute reported from the RADIUS server.
Press "A." The command prompt changes to "Enable or Disable to accept RADIUS
attribute (E/D)>." Press "E" to use the Attribute from the RADIUS server or "D" to
use the setting of this switch.
G
Set the guest VLAN.
Press "G." The command prompt changes to "Enter port number>." Enter the port
number to be specified. After the entry, the command prompt changes to "Enter
guest VLAN ID>." Enter an existing VLAN ID to be set as the guest VLAN.
To disable the guest VLAN, enter 0.
D
Set the default VLAN.
Press "D." The command prompt changes to "Enter port number>." Enter the port
number to be specified. After the entry, the command prompt changes to "Enter
default VLAN ID>." Enter an existing VLAN ID to be set as the default VLAN.
To disable the default VLAN, enter 0.
Q
Return to the parent menu.
Note: If the guest VLAN is set, the PVID of the target port is changed to the
guest VLAN ID.
- Tunnel-Private-Group-ID
Uses the reported Attribute. (Factory default
setting)
Uses the setting of this switch.
The authentication function is disabled, or the port is
already authorized by IEEE802.1X port-based access
control.
The port is on standby for IEEE802.1X MAC-based
access control, MAC authentication, or WEB
authentication.
212
Advertisement
Table of Contents
