Panasonic PN28080i-ID Operation Manual page 74

4.6.3.o Set IPv6 Trap Receiver
On the SNMP Trap Receiver Configuration Menu, pressing "P" opens the Set
IPv6 Trap Receiver Menu, as shown in Fig. 4-6-20. On this screen, you can set
SNMP trap receiver.
PN28080i Local Management System
SNMP Trap Receiver Configuration Menu -> Set IPv6 Trap Receiver Menu
Trap Receiver List:
No. IPv6 Address
----------------------------------------------
1 ::
2 ::
3 ::
4 ::
5 ::
6 ::
7 ::
8 ::
9 ::
10 ::
-------------------------------- <COMMAND> -----------------------------------
Set Receiver [I]Pv6
Command>
Enter the character in square brackets to select option
Fig. 4-6-20 SNMP Trap Receiver Configuration (IPv6)
Screen Description
Trap Receiver Shows the current SNMP trap receiver settings.
List:
No.
IPv6 Address
Available commands are listed below.
I Set an IPv6 address for an SNMP trap receiver.
Press "I." The command prompt changes to "Enter manager entry number>." Enter
an SNMP trap receiver entry number you wish to configure. Then, the command
prompt changes to " Enter new receiver IPv6 address>." Enter an IPv6 address.
Q Return to the previous menu.
[Q]uit to previous menu
Shows the entry number on the SNMP trap receiver List.
Shows the IPv6 address of the SNMP trap receiver.
74