Speco N64NR24TB User Manual page 26

Camera Management
Add Manually

Enter the IP address or domain name (click
enter the domain name of the IPC in the window and then click "OK" button), port, username and password of the
camera and then select the protocol. Click "Test" to test the effectiveness of the input information and then click
"Add" button (you can input one camera's information or above such as IP address, username and password before
clicking "Add" button). Click
password of each camera.
Note: Some models may not support this function.
Click StartSettingsSystemBasicGeneral Settings to check "Enable Add IPC by Zero Operation". If the NVR has
unoccupied channels, it can add IPC without any operation by restarting.
Add Recorder

Quickly Add：Select the searched NVR/DVR and the click "Add" to add NVR in the same local network.

Manually Add：Click "Manual Add" and then enter the IP address or domain name, port, username and

in the IP address column to pop up the domain name input window,
to delete the camera. Click "Default Password" to set the default username and
19
NVR User Manual