Speco N64NR24TB User Manual page 68

Alarm Management
2 Select the camera, enable the face detection and set the duration.
If the added cameras are face detection cameras, on (front) or off (front) can be selected.
3 Enable save source information and save face information.
4 Select the alarm area. Draw the alarm area of the intrusion detection. Refer to the interface as shown below.
Check "Draw area" and then drag the mouse to draw a detection area. Click "Clear" to delete the alarm area.
5 Click "Apply" to save the settings.
6 Click "Processing Mode" to go to the alarm handling configuration interface of face detection.
Face Detection Alarm Handling Configuration:
1 Click StartSettingsAlarm Face Detection to go to the following interface.
2 Enable or disable "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail". The alarm
handling setting of face detection alarm is the same as the sensor alarm (see
Click "Apply" to save the settings. You can click "Face Detection Config" to go to the face detection configuration
interface.
9.1 Sensor Alarm
61
NVR User Manual
for details).