Reread Timeout - Newland NLS-HR32-BT User Manual

Reread Timeout

Reread Timeout can avoid undesired rereading of same barcode in a given period of time. This feature is only applicable to
the Sense and Continuous modes.
Enable Reread Timeout: Do not allow the scanner to reread same barcode before the reread timeout expires.
Disable Reread Timeout: Allow the scanner to reread same barcode.
Enable Reread Timeout
The following parameter sets the time interval between two successive reads on same barcode. It is programmable in 1ms
increments from 0ms to 3,600,000ms. When it is set to a value greater than 3,000, the timeout for rereading same
programming barcode is limited to 3,000ms. The default setting is 1,500ms.
Set the reread timeout to 1,000ms:
1. Scan the Enter Setup barcode.
2. Scan the Set Reread Timeout barcode.
3. Scan the numeric barcodes "1", "0", "0" and "0" from the "Digit Barcodes" section in Appendix.
4. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
5. Scan the Exit Setup barcode.
33
Set Reread Timeout
Enter Setup
** Disable Reread Timeout
** Exit Setup