Newland NLS-HR32-BT User Manual page 55

Program the scanner to only read Barcode 1 in the figure above by setting the decoding area to
10% top, 45% bottom, 15% left and 30% right:
1. Scan the Enter Setup barcode.
2. Scan the
3. Scan the numeric barcode "0" from the "Digit Barcodes" section in Appendix.
4. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
5. Scan the
6. Scan the numeric barcodes "4" and "5" from the "Digit Barcodes" section in Appendix.
7. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
8. Scan the
9. Scan the numeric barcodes "1" and "0" from the "Digit Barcodes" section in Appendix.
10. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
11. Scan the
12. Scan the numeric barcode "0" from the "Digit Barcodes" section in Appendix.
13. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
14. Scan the
15. Scan the numeric barcodes "3" and "0" from the "Digit Barcodes" section in Appendix.
16. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
17. Scan the
18. Scan the numeric barcodes "1" and "5" from the "Digit Barcodes" section in Appendix.
19. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
20. Scan the Exit Setup barcode.
39
Barcode 1
Top of Decoding Area barcode.
Bottom of Decoding Area
Top of Decoding Area barcode.
Left of Decoding Area barcode.
Right of Decoding Area barcode.
Left of Decoding Area barcode.
Barcode 2
barcode.
Enter Setup
** Exit Setup